1. Before installation, it is necessary to confirm whether the motor and reducer are in good condition, and check whether the dimensions of all parts connected to the motor reducer match.
2. Atsukite the screw on the dust-proof hole outside the flanšas of the reduktorius, adjust the PCS system clamping ring so that the side hole is aligned with the dust-proof hole, and screw it into the in inter hexagon to priveržkite.
3. When connecting the reducer, it is necessary to ensure that the output shaft of the reducer is concentric with the input shaft of the motor, and that the outer flanges of the two are parallel. If the concentricity is not good, it may cause the motor shaft to break or the reducer gear to wear.